Configuring Junos Os On The Ex4500; Ex4500 Default Configuration - Juniper EX4500 Hardware Manual

2. Connect the other end of the Ethernet cable to the console server (see
management console (see
Figure 47: Connect a Device to a Management Console Through a Console Server
To Console Port
Figure 48: Connect a Device Directly to a Management Console
To Console port

Configuring Junos OS on the EX4500

IN THIS SECTION

EX4500 Default Configuration | 142

Connecting and Configuring an EX Series Switch (CLI Procedure) | 149
Connecting and Configuring an EX Series Switch (J-Web Procedure) | 153
Configuring the LCD Panel on EX Series Switches (CLI Procedure) | 157
EX4500 Default Configuration
Each EX Series switch is programmed with a factory default configuration that contains the values set for
each configuration parameter when a switch is shipped. The default configuration file sets values for
system parameters such as syslog and commit, configures Ethernet switching on all interfaces, enables
IGMP snooping, and enables the LLDP and RSTP protocols.
Figure 48 on page 142).
Console Server
PC
Figure 47 on page 142) or
PC
142