Lcd Panel Menus - Juniper EX4500 Hardware Manual

In the maintenance mode, the second line displays one of the following options that you can use to configure
and troubleshoot the switch:
System halt
System reboot
Load rescue
Request VC port (supported only on EX4500 switches in a Virtual Chassis configuration running Junos OS
Release 11.1 or later. This option is not supported on standalone EX4500 switches.)
Factory default
EZSetup

LCD Panel Menus

The LCD panel has three menus: Idle, Status, and Maintenance. You can toggle between the LCD panel
menus by pressing the Menu button and navigate through the menu options by pressing the Enter button.
Table 6 on page 40 describes the LCD panel menu options.
Table 6: LCD Panel Menu Options in EX4500 Switches
Menu
IDLE
Description
In the Idle menu:
Press Enter to cycle through the Status LED modes, which are port status
indicators:
ADM (administrative status)
DPX (duplex)
SPD (speed)
See "Network Port and Uplink Module Port LEDs in EX4500 Switches" on
page 52 for information on the Status LED modes.
Press Menu to exit the Idle menu and go to the Status menu.
40