Juniper EX4500 Hardware Manual page 152

5. Enable services such as SSH and Telnet.
NOTE: You will not be able to log in to the switch as the root user through Telnet. Root login
is allowed only through SSH.
The default option for SSH is yes. Select this to enable SSH.
The default option for Telnet is no. Change this to yes to enable Telnet.
6. Use the Management Options page to select the management scenario:
NOTE: On EX2300 and EX3400 switches, you cannot create a new VLAN for management.
On EX4500, EX6200, and EX8200 switches, only the out-of-band management option is
available.
Configure in-band management. In in-band management, you configure a network interface or an
uplink module (expansion module) interface as the management interface and connect it to the
management device.
In this scenario, you have the following two options:
Use the automatically created VLAN default for management—Select this option to configure all
data interfaces as members of the default VLAN. Specify the management IP address and the
default gateway.
Create a new VLAN for management—Select this option to create a management VLAN. Specify
the VLAN name, VLAN ID, management IP address, and default gateway. Select the ports that
must be part of this VLAN.
Configure out-of-band management—Configure the management port. In out-of-band management,
you use a dedicated management channel (MGMT port) to connect to the management device.
Specify the IP address and gateway of the management interface. Use this IP address to connect to
the switch.
7. Specify the SNMP read community, location, and contact to configure SNMP parameters. These
parameters are optional.
8. Specify the system date and time. Select the time zone from the list. These options are optional.
152