Juniper EX4500 Hardware Manual page 125

Table 43: Parts Required for Connecting an EX Series Switch to Earth Ground (continued)
Earthing
Terminal
Switch Location
EX8216 Two earthing
terminals:
Left side of
the chassis
Rear panel
of the
chassis
NOTE: You
must use only
one of the
two
protective
earthing
terminals.
EX9204, Rear panel of
EX9208, the chassis
and
EX9214
EX9251 Rear panel of
the chassis
Grounding
Cable Grounding Lug
Requirements Specifications
2 AWG Panduit LCD2-14A-Q
(33.6 mm²), or equivalent
minimum 90° C —provided
wire, or as
permitted by the
local code
One 6 AWG Thomas& Betts
(13.3 mm²), LCN6-14 or
minimum 90° C equivalent—
wire, or one that provided
complies with
the local code
12 AWG Panduit
(2.5 mm²), LCD10-10A-L or
minimum 90° C equivalent—
wire, or one that not provided
complies with
the local code—
not provided
Screws and Additional
Washers Information
Two ¼ -20 x
0.5 in. screws
with #¼"
split-washer
—provided
Two #¼" flat
washers—
provided
Two ¼ -20 See Grounding Cable
x 0.5 in. screws and Lug Specifications
with #¼" for EX9200
split-washer—
provided
Two #¼" flat
washers—
provided
Two 10-32 See Grounding Cable
screws— and Lug Specifications
provided for EX9200
125
Switches.
Switches.