Connect A Fiber-Optic Cable - Juniper EX4500 Hardware Manual

own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled loop in the
cable management system. Placing fasteners on the loop helps to maintain its shape.
CAUTION:
fastened loops of cable to dangle, which stresses the cable at the fastening point.
CAUTION:
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
Figure 42: Install a Transceiver
1 Ejector lever
—

Connect a Fiber-Optic Cable

Before you connect a fiber-optic cable to an optical transceiver installed in a device, ensure that you have
taken the necessary precautions for safe handling of lasers (see
Warnings" on page 291).
Do not let fiber-optic cable hang free from the connector. Do not allow
Avoid bending fiber-optic cable beyond its minimum bend radius. An
"Laser and LED Safety Guidelines and
138