Maintaining Ex4500 Virtual Chassis Module; Removing A Virtual Chassis Module From An Ex4500 Switch - Juniper EX4500 Hardware Manual

Figure 65: Installing an Intraconnect Module in an EX4500 Switch
NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade
of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
result in significant delays if you need replacement parts. This note does not apply if you replace
existing components with the same type of component.

Maintaining EX4500 Virtual Chassis Module

IN THIS SECTION

Removing a Virtual Chassis Module from an EX4500 Switch | 215

Installing a Virtual Chassis Module in an EX4500 Switch | 218
Removing a Virtual Chassis Module from an EX4500 Switch
The Virtual Chassis module is installed horizontally on the rear panel of the switch. See
EX4500 Switch" on page
switch chassis.
36. Use the procedure described in this topic to remove the module from the
. Failure to do so can
"Rear Panel of an
215