Advertisement
9. Continue to support the router while sliding the rear mounting-blades into the channel of the side mounting-rails and
securing the blades to the rack. Use the four mounting screws (and cage nuts and washers if your rack requires them)
to attach each blade to the rack. Tighten the screws.
10. Ensure that the router chassis is level by verifying that all the screws on the front of the rack are aligned with the
screws at the back of the rack.
ALM
SYS
ID
CON
MGMT
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
11. Attach a grounding cable to earth ground and then attach it to the chassis grounding points (on the side of the chassis).
Part 2: Connect Power to an AC-Powered Router
NOTE:
For instructions on connecting DC power, see the installation instructions in the PTX10001 documentation
at https://www.juniper.net/documentation/product/en_US/ptx10001.
To connect power to a PTX10001 with AC power supplies:
1. If the AC power source outlet has a power switch, set it to the OFF (0) position.
2. Insert the coupler end of the power cord into the AC power cord inlet on the AC power supply faceplate.
3. Push the power cord retainer onto the power cord.
4. Insert the power cord plug into the power source outlet.
5. If the AC power source outlet has a power switch, set it to the ON (|) position.
6. Verify that the AC and the DC LEDs are lit green and on steadily.
3
Advertisement
