Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 72

Pro Synth Mod
Freq B
0.0-36.0. This sets the depth of oscillator B frequency modulation, in half-steps. This
routing is turned on and off by the Freq B switch, in the Controller Mod section.
PW A
0-100 This sets the depth of oscillator A pulse width modulation. This routing is
turned on and off by the PW A switch, in the Controller Mod section.
PW B
0-100 This sets the depth of oscillator B pulse width modulation. This routing is
turned on and off by the PW B switch, in the Controller Mod section.
Filter
0-100 This sets the depth of filter cutoff modulation. This routing is turned on and
off by the Filter switch, in the Controller Mod section.
Glide
Glide
0-100. This sets the glide amount (also known as portamento) for the oscillator,
which makes the pitch slide smoothly between notes. At 0, Glide is completely off.
At 100, notes will take a long time to glide to the new pitch.
Note that the effects of glide will also vary depending on the Patch's voice
allocation setting, in the Program Edit window. Poly Retrig, Poly Reuse, Mono
Legato, and Unison modes are generally the most suitable for use with Glide, but
you may find that you like other settings as well.
Amp AR
The Amp Env switch determines whether the amplifier will use this simple AR
envelope, or the more complex Amp ADSR envelope. Switching to the AR envelope
allows you to use the ADSR envelope as a poly mod source, and adjust it as desired
without affecting the output volume.
Attack
0-100. This sets the attack time of the AR envelope. This is the time that it takes
from the moment that the key is pressed until the envelope reaches its peak.
Release
0-100. This sets the release time of the AR envelope. This is the time that it takes
from the moment that the key is released until the envelope falls to zero.
64
Analog Synths
OASYS PCI