Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 233

Waveguide
Amount
0-100. This sets the amount by which the mod source affects the growl.
Horn
Glide
0-100. This models the time that the horn takes to transition between notes.
Bell Width
0-5000Hz. This models the width of the saxophone's bell, which acts as a highpass
filter.
Bell Level
0-100. This is the volume level from the saxophone's bell, like putting a mic at the
end of the horn.
Bore Level
0-100. This is the volume level from within the saxophone's bore, like putting a mic
inside the sax. Mixing the bore with the bell allows additional control over the tone.
LFO
The LFO includes individual amounts to vibrato (for pitch modulation), bore (for
brightness modulation), and breath pressure.
Frequency
0.0-10.0 Hz. This controls the initial speed of the LFO.
Frequency Mod
List of Modulation Sources. This sets the modulation source for controlling the
LFO frequency. For a complete list, please see "Modulation Sources" on page 2.
Amount
0.0-10.0Hz. This sets the amount, in Hz, by which the mod source affects the LFO
frequency. When the mod source is at its maximum value, it will add this amount to
the setting on the Frequency knob.
Depth Controller
List of Modulation Sources. This sets the modulation source for controlling the
LFO depth. For a complete list, please see "Modulation Sources" on page 2.
Vibrato Amount
0.00-100.00. This sets the amount by which the mod source affects the pitch
modulation depth.
OASYS PCI
Tenor Sax
225