Rez Filter Seq - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Filters

Rez Filter Seq

This effect combines a resonant multimode, multi-pole filter with an ADSR
envelope and an analog-style sequencer.
Input
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Filter
Cutoff
0-100. This controls the cutoff frequency of the filter. The meaning of the cutoff
frequency will change depending on the filter mode.
When the filter is set to Lowpass mode, frequencies above the cutoff are attenuated,
and frequencies below the cutoff are passed through unchanged.
When the filter is set to Highpass mode, frequencies below the cutoff will be
attenuated, and frequencies above the cutoff will pass through unchanged.
When the filter is set to Bandpass mode, frequencies both above and below the
cutoff will be attenuated, and only frequencies right at the cutoff will pass through
unchanged.
Note that the Envelope and Key Track parameters also affect the cutoff frequency.
This control has extra smoothing on the DSP, to ensure zipper-free modulation. If
instantaneous modulation is desired (such as modulation via velocity), modulate
the Envelope control instead.
Seq Mod Amt
+/-100. This sets the amount of cutoff modulation from the sequencer.
Key Track
+/-100. This adjusts the filter cutoff in response to incoming MIDI notes, centered
on E4, as shown below. Note that you can also modulate any parameter using the
"Key Tracking" modulators in the Mod Palette.
OASYS PCI
Rez Filter Seq
429