Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 64

Hide thumbs Also See for Soundlink DRS OASYS PCI:
Table of Contents

Advertisement

Pro Synth
Filter
On, Off. This selects the filter cutoff as a modulation destination.
Mod Controller
List of Modulation Sources. This sets the source for controlling the amount of the
Source Mix sent to the selected destinations. For a complete list, please see
"Modulation Sources" on page 2.
Initial
0-100. This sets the amount of the Source Mix which will be applied to the selected
destinations, even when the Mod Controller is at zero. Some of the sounds on the
original synth called for you to set the mod wheel to the middle of its range, and
then leave it there; you can use the Initial amount to replicate this.
Glide
Glide
0-100. This sets the glide amount (also known as portamento) for the oscillator,
which makes the pitch slide smoothly between notes. At 0, Glide is completely off.
At 100, notes will take a long time to glide to the new pitch.
Note that the effects of glide will also vary depending on the Patch's voice
allocation setting, in the Program Edit window. Poly Retrig, Poly Reuse, Mono
Legato, and Unison modes are generally the most suitable for use with Glide, but
you may find that you like other settings as well.
Release
On, Off. This enables the release segments of the envelopes. If this is turned off, the
envelopes will fall to zero immediately on note off.
Volume
+12 to -123.9dB, -INF. This is the output volume for the Patch.
This control has extra smoothing on the DSP, to ensure zipper-free modulation. If
you want to modulate the volume instantaneously via velocity, use the Vel Sens
control instead.
IMPORTANT: The output volume provides up to 12dB in gain, so that you can get
your signals as hot as possible. However, if filter resonance is high, settings above
0dB may cause clipping.
Vel Sens (Velocity Sensitivity)
0-100. This sets the sensitivity of output volume to velocity. A velocity of 127 will
always result in the maximum output level, as set by the Volume control; increasing
the Vel Sens will decrease the output volume for low velocities.
56
Analog Synths
OASYS PCI

Advertisement

Table of Contents
loading

Table of Contents