Room Reverb - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Reverbs

Room Reverb

This is a Room Reverb effect, using a standard comb-filter reverb topology.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Pre EQ
Low Freq
0-10000Hz. This sets the cutoff frequency of the pre-effect low shelving EQ, in Hz.
This is the point at which gain is 3dB below maximum, as shown in the figure
"High and Low Shelving EQ," on page 382.
Low Gain
+/-18.1dB. This sets the amount of gain for the pre-effect low shelving EQ.
High Freq
0-20000Hz. This sets the cutoff frequency of the pre-effect high shelving EQ, in Hz.
This is the point at which gain is 3dB below maximum, as shown in the figure
"High and Low Shelving EQ," on page 382.
High Gain
+/-18.1dB. This sets the amount of gain for the pre-effect high shelving EQ.
ER 1-4
The reverb has four early reflection delays, each with similar parameters.
Time
0.0-200.0ms. This is the delay time of the early reflection, in milliseconds.
Level
0-100. This is the volume level of the early reflection.
OASYS PCI
Room Reverb
627