Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 21

Analog Synths
Waveform
Sine, Triangle, Saw, Square. This sets the shape of the LFO.
LFO Mod
Oscillator Freq
On, Off. When this is enabled, the LFO will modulate the pitch of the oscillator.
Pulse Width
On, Off. When this is enabled, the LFO will modulate the oscillator's pulse width.
Filter Cutoff
On, Off. When this is enabled, the LFO will modulate the filter cutoff frequency.
Initial
0-100. This sets the initial amount of LFO modulation.
Mod Source
List of Modulation Sources. This sets the modulation source for controlling the
LFO amount. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
0-100. This sets the amount by which the mod source affects the LFO amount.
Output
Volume
+12 to -123.9dB, -INF. This is the output volume for the Patch.
IMPORTANT: The output volume provides up to 12dB in gain, so that you can get
your signals as hot as possible. However, if filter resonance is high, settings above
0dB may cause clipping.
This control has extra smoothing on the DSP, to ensure zipper-free modulation. If
you want to modulate the volume instantaneously via velocity, use the Vel Sens
control instead.
Vel Sens (Velocity Sensitivity)
0-100. This sets the sensitivity of output volume to velocity. A velocity of 127 will
always result in the maximum output level, as set by the Volume control; increasing
the Vel Sens will decrease the output volume for low velocities.
OASYS PCI
Analog 1 Osc
13