Delay
Feedback Mod
List of Modulation Sources. This sets the modulation source for controlling the
delay feedback level. For a complete list, please see "Modulation Sources" on
page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the feedback level.
Spread
Spread
+/-100. This controls the width of the stereo image. Negative values will flip the
stereo placement.
Spread Mod
List of Modulation Sources. This sets the modulation source for controlling the
stereo spread. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the stereo spread.
Damping
High Damping
0-100. This filter cuts the delay's high frequencies. Use this to make the delay sound
warmer, like a tape delay.
Low Damping
0-100. This filter cuts the delay's low frequencies. Use this to make the delay sound
thinner.
Output
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the wet/dry mix.
OASYS PCI
St Delay
339