Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 569

Phasers
On. When this is on, the envelope will be triggered whenever a key is pressed.
Off. When this is off, the envelope will only be retriggered after all currently held
notes have been released.
EG Attack
0-100. This sets the attack time of the envelope–the time that it takes to reach its
maximum value after being triggered.
EG Decay
0-100. This sets the release time of the envelope–the time that it takes to fall back to
its minimum value after the trigger is released.
Resonance
+/-100. This sets the amount of resonance in the phaser effect. Higher resonance
settings create a more extreme sound.
Damping
0-100. This controls the amount of high frequency damping in the phaser
resonance.
Output
Mode
Mono, Stereo. This controls whether the effect output is mono or simulated stereo.
When this is set to Mono, the output is in mono.
When this is set to Stereo, the output is simulated stereo, with the right effect
output inverted. Note that this simulated stereo effect is not mono-compatible.
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the wet/dry mix.
Invert Wet Phase
On, Off. This allows you to invert the phase of the wet signal.
OASYS PCI
Envelope Phaser
561