Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 110

Argon 4+
Sustain
0-100. This sets the sustain level for the amplitude envelope. After the decay time is
complete, the envelope will stay at this level as long as the note is held.
Release
0-100. This sets the release time of the amplitude envelope, which controls how
long it takes the envelope to fall to zero after the note is released.
Amp Mod
LFO 1
0.0-100.0. This sets the amount by which LFO 1 modulates amplitude.
LFO 2
0.0-100.0. This sets the amount by which LFO 2 modulates amplitude.
Volume
+12 to -123.9dB, -INF. This is the output volume for the Patch.
IMPORTANT: The output volume provides up to 12dB in gain, so that you can get
your signals as hot as possible. However, if filter resonance is high, settings above
0dB may cause clipping.
This control has extra smoothing on the DSP, to ensure zipper-free modulation. If
you want to modulate the volume instantaneously via velocity, use the Vel Sens
control instead.
Vel Sens (Velocity Sensitivity)
0-100. This sets the sensitivity of output volume to velocity. A velocity of 127 will
always result in the maximum output level, as set by the Volume control; increasing
the Vel Sens will decrease the output volume for low velocities.
Global LFO 1
Waveform
Waveform
Triangle, Sine, Saw Up, Saw Down, Square, Sample & Hold. This selects the
waveform of the LFO.
102
PCM
OASYS PCI