Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 441

Filters
Run/Stop Mod
List of Modulation Sources. This sets the modulation source for starting and
stopping the sequence. For a complete list, please see "Modulation Sources" on
page 2.
Run/Stop Mode
Momentary, Toggle. This determines the behavior of the run/stop modulator.
Momentary. The the run/stop state is changed only as long as the switch is on.
When the switch is released, it returns to the previous state.
Toggle. The switch turns the sequencer on and off alternately. Switching once turns
it on; switching again turns it off.
Tempo Source
Knob, Midi Tempo. This sets whether the sequencer will use the tempo set by the
Tempo knob, or tempo received via MIDI.
Tempo
40-240Hz. This sets the tempo, in beats per minute, when the Tempo Source is set to
Manual Tempo. If the Tempo Source is set to MIDI Tempo, this knob is ignored.
Step Value
1/32, 1/32 dotted, 1/16, 1/16 dotted, 1/16 triplet, 1/8, 1/8 dotted, 1/8 triplet, 1/4, 1/4
dotted, 1/4 triplet, 1/2, 1/2 dotted, 1/2 triplet, 1 bar, 2 bars. This sets the note value
of the steps in the sequence.
Loop Start
1-16. The sequence will always start at step 1, but when it begins to repeat, it will
jump to the step specified here. You can modulate this via MIDI, to create
fluctuating patterns.
Loop End
1-16. This sets the end step for the sequence. When the sequence completes this
step, it will return to the Loop Start.
Step Width
0-100. This sets the duration of the sequencer pulses. This parameter is particularly
suited to real-time modulation.
Attack
0-100. This sets the attack time for the sequencer pulses.
Decay
0-100. This sets the decay time for the sequencer pulses.
OASYS PCI
Rez Filter Seq
433