Vibrato - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Vibrato

Vibrato
This is a mono-in, stereo-out vibrato effect.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Vibrato
Depth
0-100. This controls the depth of the vibrato.
Depth Mod
List of Modulation Sources. This sets the modulation source for controlling the
vibrato depth. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the vibrato depth.
Filter
Lowpass Filter
On, Off. This enables and disables the built-in lowpass filter.
Cutoff
0-100. This sets the cutoff frequency of the lowpass filter.
LFO Depth
+/-100. This sets the amount of LFO modulation for the filter.
LFO Depth Mod
List of Modulation Sources. This sets the modulation source for controlling the
filter LFO depth. For a complete list, please see "Modulation Sources" on page 2.
500
Modulations
OASYS PCI