Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 440

Rez Filter Seq
Type
4 Pole, 2 Pole, 2 Pole > 2 Pole. This parameter selects the amount of frequency
attenuation in the filter, and the character of the resonance.
4 Pole. This is a 24dB per octave filter. Of the three types, the 4 Pole offers the
greatest attenuation of frequencies beyond the cutoff, coupled with a resonance
slightly more delicate than the 2 Pole type. Many classic analog synths used this
general type of filter.
2 Pole. This is a 12dB per octave filter. Compared to the 4 Pole, this offers
significantly less attenuation of frequencies beyond the cutoff, but with slightly
more pronounced resonance.
2 Pole > 2 Pole. This is two 12dB per octave filters in series. Of the three types, this
offers by far the most extreme resonance effect. Compared with the 4 Pole, it has
just a little less attenuation of frequencies beyond the cutoff.
LFO Mod Depth
Frequency
0.00-10000Hz. This sets the frequency of the LFO.
Waveform
Sine, Triangle, Saw, Square. This selects the shape of the LFO.
LFO Reset
List of Modulation Sources. This sets the modulation source for resetting the LFO
phase. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the LFO speed.
Cutoff Mod
+/-100. This sets the amount by which the LFO affects the filter cutoff.
Resonance Mod
+/-100. This sets the amount by which the LFO affects the filter resonance.
Baseline Mod
+/-100. This sets the amount by which the LFO affects the sequencer baseline.
Step Sequencer
Initial State
Run, Stop. This controls whether the sequence is running or stopped when first
opened.
432
Filters
OASYS PCI