Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 41

Analog Synths
Sustain
0-100. This sets the sustain level for the amplitude envelope. After the decay time is
complete, the envelope will stay at this level as long as the note is held.
Release
0-100. This sets the release time of the amplitude envelope, which controls how
long it takes the envelope to fall to zero after the note is released.
LFO
Frequency
0.0-20.0 Hz. This controls the speed of the LFO.
Waveform
Sine, Triangle, Saw, Square. This sets the shape of the LFO.
LFO Mod
Oscillator Freq
On, Off. When this is enabled, the LFO will modulate the pitch of the oscillator.
Pulse Width
On, Off. When this is enabled, the LFO will modulate the oscillator's pulse width.
Filter Cutoff
On, Off. When this is enabled, the LFO will modulate the filter cutoff frequency.
Initial
0-100. This sets the initial amount of LFO modulation.
Mod Source
List of Modulation Sources. This sets the modulation source for controlling the
LFO amount. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
0-100. This sets the amount by which the mod source affects the LFO amount.
Output
Volume
+12 to -123.9dB, -INF. This is the output volume for the Patch.
This control has extra smoothing on the DSP, to ensure zipper-free modulation. If
you want to modulate the volume instantaneously via velocity, use the Vel Sens
control instead.
OASYS PCI
Comb Synth
33