Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 28

Analog 2 Osc
Sustain
0-100. This sets the sustain level for the amplitude envelope. After the decay time is
complete, the envelope will stay at this level as long as the note is held.
Release
0-100. This sets the release time of the amplitude envelope, which controls how
long it takes the envelope to fall to zero after the note is released.
LFO
Frequency
0.0-20.0 Hz. This controls the speed of the LFO.
Waveform
Sine, Triangle, Saw, Square. This sets the shape of the LFO.
LFO Mod
Osc 1 & 2 Frequency
On, Off. When this is enabled, the LFO will modulate the pitch of the oscillators.
Filter Cutoff
On, Off. When this is enabled, the LFO will modulate the filter cutoff frequency.
Pulse Width 1 & 2
On, Off. When this is enabled, the LFO will modulate the pulse width of the
oscillators.
Resonance
On, Off. When this is enabled, the LFO will modulate the filter resonance.
Initial
0-100. This sets the initial amount of LFO modulation.
Mod Source
List of Modulation Sources. This sets the modulation source for controlling the
LFO amount. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
0-100. This sets the amount by which the mod source affects the LFO amount.
20
Analog Synths
OASYS PCI