Vibrato Chorus - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

Vibrato Chorus

Vibrato Chorus
This is a physical model of the tonewheel organ's classic vibrato-chorus effect.
Input
Source
Left, L + R. This is a mono-in, stereo-out effect. Stereo signals are preserved in the
dry mix at the output, but the effect itself has only a single, mono input.
When this is set to Left, only the left channel will be routed into the effect.
When this is set to L + R, the left and right channels will be summed together, and
then routed into the effect.
Level
-INF, -69.0 to 0.0dB. This sets the input level for the effect. It does not affect the dry
signal.
Vibrato Chorus
Cutoff
0-100. The chorus is made from a series of lowpass filters; this is the cutoff
frequency of those filters.
LFO Rate
0.10-20.00Hz. This sets the speed of the LFO. In the original effect, the frequency
was fixed at 6.9Hz.
LFO Amt
0-100. This controls the amount of LFO modulation.
LFO Offset
0-100. This sets the tap on which the LFO is centered.
Output
Wet
+/-100. This controls the output level of the wet signal. Negative values invert the
phase.
Dry
0-100. This controls the output level of the dry signal.
508
Organ FX
OASYS PCI