Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 38

Comb Synth
Key Track
+/- 100. This adjusts the filter cutoff in response to incoming MIDI notes, as shown
below. Note that you can also modulate any parameter using the "Key Tracking"
modulators in the Mod Palette.
Key Tracking
Using Key Tracking, you can "play" the pitch of the filter from the keyboard. To do
this:
1.
2.
You can raise it again later, but the effect is easiest to hear using only the noise
generator.
3.
This tunes the filter so that middle C = C4. To raise the pitch by one octave, set
Cutoff to 10; to raise by two octaves, set Cutoff to 20; and so on. To produce lower
pitches, use the Program Edit window Transpose parameter.
4.
5.
6.
7.
8.
Envelope and LFO modulation of the filter will affect the pitch.
9.
Yes, Glide affects the filter as well.
Now, the resonating filter will create a pitch, and you can play it from the keyboard.
Adjusting the Damping, Feedback, and Resonance parameters will affect the
timbre; try it out!
30
+100
0
-100
A0 E4
MIDI Note
Set the Noise to 100.
Set the Oscillator's Level to 0.
Set Cutoff to 0.
Set Resonance to 100.
Set Key Track to 100.
Set Damping relatively high (try 90).
Set Envelope to 0.
Turn off the Filter Cutoff button in the LFO Mod section.
Set Glide as desired.
Key Track amount
+100
+50
0
-50
-100
C8
Analog Synths
OASYS PCI