Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 20

Analog 1 Osc
Release
0-100. This sets the release time of the filter envelope, which controls how long it
takes the envelope to fall to zero after the note is released.
ADSR Envelope
Amplifier
These parameters control an ADSR envelope dedicated to the output volume. For a
graphic explaining ADSR envelopes, see the figure "ADSR Envelope," above.
Attack
0-100. This sets the attack time of the amplitude envelope, which controls how long
it takes from the moment that the key is pressed until the envelope reaches its peak.
Decay
0-100. This sets the decay time of the amplitude envelope, which controls how long
it takes the envelope to fall to the sustain level after the attack is complete.
Sustain
0-100. This sets the sustain level for the amplitude envelope. After the decay time is
complete, the envelope will stay at this level as long as the note is held.
Release
0-100. This sets the release time of the amplitude envelope, which controls how
long it takes the envelope to fall to zero after the note is released.
LFO
Frequency
0.0-20.0 Hz. This controls the speed of the LFO.
12
Attack time Decay time
Sustain
Level
Sustain while Release time
holding note
Analog Synths
OASYS PCI