Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 482

StTempoFlange2
Step Freq
0.00-80.00Hz. This controls the speed of the step LFO when the LFO Control is set
to Frequency Knob.
Step Freq Mod
List of Modulation Sources. This sets the modulation source for controlling the
speed of the step LFO. For a complete list, please see "Modulation Sources" on
page 2.
Step Mod
+/-80.00Hz. This sets the amount by which the mod source affects the speed of the
step LFO.
Step Control
Frequency Knob, Manual Tempo, MIDI Tempo. The speed of the step LFO can be
controlled either by the Frequency knob (including the mod source), the Manual
Tempo knob, or by MIDI Tempo (derived from MIDI clocks).
If this is set to Frequency Knob, then the step LFO speed will be controlled by the
settings in the Frequency section, including the mod source and amount.
If this is set to Manual Tempo, then the Manual Tempo knob will set the basic
tempo, and the note value set in the Subdivisions menu will control the step LFO
speed.
If this is set to MIDI Tempo, then incoming MIDI Clocks will set the basic tempo,
and the note value set in the Subdivisions menu will control the step LFO speed.
Step Tempo
Manual Tempo
40-240 bpm. This sets the tempo when the Step Control is set to Manual Tempo.
Subdivision
1/32, 1/32 dotted, 1/16, 1/16 dotted, 1/16 triplet, 1/8, 1/8 dotted, 1/8 triplet, 1/4, 1/4
dotted, 1/4 triplet, 1/2, 1/2 dotted, 1/2 triplet, 1 whole note, 2 whole notes. This
sets the note value of a single LFO waveform cycle when the Step Control is set to
either Manual Tempo or MIDI Tempo.
Output
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
474
Flangers
OASYS PCI