Midi Gate - Korg Soundlink DRS OASYS PCI Patches & Effects Manual

MIDI Gate

MIDI Gate
This is a mono-in, mono-out MIDI-controlled gate. Unlike the Expander Gate,
which is controlled by the input level, the MIDI Gate opens and closes via a MIDI
trigger. You can use this for manually gating a recorded signal, for precise control
over the gating process, or for special effects, such as rhythmic gating.
You can also think of this as the "amp envelope" section from an analog
synthesizer.
MIDI Gate
Volume
0-100. This sets the default volume level for signals passing through the gate. For
complete gating, set this to 0. Use low and middle values to create subtle pulsing
effects, in which the signal is always present, but triggering the gate makes it
louder.
Env Amount
0-100. This controls the amount of affect the envelope will have on the output level,
adding to the setting on the Volume knob. At 0, the envelope will have no affect. At
+100, the envelope will set the output to max at its peak, even if Volume is set to 0.
Envelope amount affect on output volume
Envelope
Attack
0-100. This sets the attack time of the amplitude envelope, which controls how long
it takes from the moment that the key is pressed until the envelope reaches its peak.
Decay
0-100. This sets the decay time of the amplitude envelope, which controls how long
it takes the envelope to fall to the sustain level after the attack is complete.
294
+100
0
Compressor & Gate
OASYS PCI