Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 480

Hide thumbs Also See for Soundlink DRS OASYS PCI:
Table of Contents

Advertisement

StTempoFlange2
If this is set to Frequency Knob, then the LFO speed will be controlled by the
settings in the Frequency section, including the mod source and amount.
If this is set to Manual Tempo, then the Manual Tempo knob will set the basic
tempo, and the note value set in the Subdivisions menu will control the LFO speed.
If this is set to MIDI Tempo, then incoming MIDI Clocks will set the basic tempo,
and the note value set in the Subdivisions menu will control the LFO speed.
Phase
Initial Phase
+/-180. This sets the point in the waveform at which the LFO starts. Whenever the
Phase Reset controller is received, the LFO will start from the Initial Phase point.
L/R Phase
+/-180. This sets the phase difference between the LFOs for the right and left
channels. Off-setting the phase between the two, as shown below, enhances the
stereo effect–although with panning in particular, the two channels must contain
fairly discrete material for this effect to be noticeable.
When using the LFO with tempo, the L/R Phase also creates a rhythmic offset
between the left and right channels. For instance, a 1/4 note LFO with an L/R
Phase of +180 creates alternating stereo 8th notes.
LFO Phase
Phase Reset
List of Modulation Sources. This sets the MIDI controller which will reset the
LFO's phase to the Initial Phase point. You can use this to trigger the LFO from a
MIDI sequencer, so that it always starts at the same point. This is especially useful
472
0° +90° +180°
–180°
–90°
Flangers
OASYS PCI

Advertisement

Table of Contents
loading

Table of Contents