Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 476

St TempoFlanger
in conjunction with MIDI Tempo synchronization. For a complete list of mod
sources, please see "Modulation Sources" on page 2.
To make sure that the LFO's phase is correct when working with a sequencer, it's
best to include the phase reset controller every few bars in the sequence, so that no
matter where you start playback, the LFO will be reset appropriately.
Frequency
The controls in the Frequency section only apply when the LFO Control is set to
Frequency Knob.
Frequency
0.00-20.00Hz. This controls the speed of the LFO when the LFO Control is set to
Frequency Knob.
Frequency Mod
List of Modulation Sources. This sets the modulation source for controlling the
LFO speed. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-20.00Hz. This sets the amount by which the mod source affects the LFO speed.
Tempo
Manual Tempo
40-240 bpm. This sets the tempo when the LFO Control is set to Manual Tempo.
Subdivision
1/32, 1/32 dotted, 1/16, 1/16 dotted, 1/16 triplet, 1/8, 1/8 dotted, 1/8 triplet, 1/4, 1/4
dotted, 1/4 triplet, 1/2, 1/2 dotted, 1/2 triplet, 1 whole note, 2 whole notes. This
sets the note value of a single LFO waveform cycle when the LFO Control is set to
either Manual Tempo or MIDI Tempo.
Output
Wet/Dry
Dry, 1:99-99:1, Wet. This sets the balance between the effect and the dry signal.
Wet/Dry Mod
List of Modulation Sources. This sets the modulation source for controlling the
wet/dry mix. For a complete list, please see "Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the wet/dry mix.
468
Flangers
OASYS PCI