Korg Soundlink DRS OASYS PCI Patches & Effects Manual page 337

Hide thumbs Also See for Soundlink DRS OASYS PCI:
Table of Contents

Advertisement

Delay
Center
-INF, -69.0 to 0.0dB. This sets the output level for the center delay.
Right
-INF, -69.0 to 0.0dB. This sets the output level for the right delay.
Center Feedback
This section controls the feedback for the center delay.
Feedback
+/-100. This adjusts the amount of feedback from the tap back into the delay line.
Negative values invert the phase of the feedback.
Feedback Mod
List of Modulation Sources. This sets the modulation source for controlling the
delay feedback levels, affecting all three taps equally. For a complete list, please see
"Modulation Sources" on page 2.
Mod Amount
+/-100. This sets the amount by which the mod source affects the feedback level.
Damping
Position
Pre Delay, Feedback Loop. This controls the position of the filters within the delay
effect.
Pre Delay. The damping filters are applied on input only.
Feedback Loop. The feedback goes through the damping filters, so that the
feedback becomes increasingly filtered.
High
0-100. This filter cuts the delay's high frequencies. Use this to make the delay sound
warmer, like a tape delay.
Low
0-100. This filter cuts the delay's low frequencies. Use this to make the delay sound
thinner.
Stereo Spread
Spread
+/-100. This controls the width of the stereo image. Negative values will flip the
stereo placement.
OASYS PCI
L-C-R Dly Long
329

Advertisement

Table of Contents
loading

Table of Contents