Batch Operation And Stop Method; Group Operation And Stop Method; Registering Zones - Daikin FTX-N/U Manual

FTX-N/U, FVXS-N, FDMQ-R Series
• If the zone number in the zone screen is dis-
played as "---," this indicates that no units are
registered in a zone.
Please perform zone registration before pro-
ceeding in the zone screen. (See page 9)

Batch operation and stop method

(Fig. 4)
This is for operating or stopping all connected units at
once.
A. What to do when operating or stopping all
connected units at once.
1.
Press either
"
• Operation can be performed from the indi-
vidual screen, the all screen, or the zone
screen.
• The "TEMPERATURE ADJUSTMENT" and
"OPERATION MODE SELECTOR" buttons
cannot be used.
To set the temperature and operation mode,
use B. batch operation.
B. Batch Operation
1.
Press the "ALL/INDIVIDUAL button" to
enter the all screen.
The " " display lights up on all registered units.
2.
Press the "SELECT" button.
The " " display lights up on all connected units.
Press the "RESET" button.
The " " display goes off on all connected units.
Operation and stop in the batch screen are done
the same as with the batch operation and batch
stop buttons.
3.
Press the "TEMPERATURE ADJUST-
MENT" button.
The temperature rises 1° every time
the ( ) button is pressed.
The temperature drops 1° every time
the ( ) button is pressed.
Set to "
setting for the temperature setting.
Setting to 1° above or below the temperature
setting range displays "
4.
Call up the desired mode by pressing
the "OPERATION MODE SELECTOR" but-
ton.
Set to "
ting for the operation setting.
9
" " or
".
" when you do not wish to use batch
".
" when you do not wish to use batch set-

Group operation and stop method

(Fig. 5)
This is for operating or stopping connected units in
groups.
[Group operation]
1.
Press the "ALL/INDIVIDUAL button"
to enter the individual screen.
The unit will enter the individual screen automati-
cally if nothing is done for one minute.
2.
Using the arrow keys,
to select the units to operate or stop.
" "
Keeping the button pressed down will move it
rapidly.
The " " in this screen has selected unit 1-04.
3.
Press the "SELECT" button.
The " " display lights up in the group.
Press the "RESET" button.
The " " display goes off in the group.
4.
Press the "TEMPERATURE ADJUST-
MENT" button.
The temperature rises 1° every time the
( ) button is pressed.
The temperature drops 1° every time the
( ) button is pressed.
Temperature adjustment cannot be done if the
selected group's air conditioners are in fan mode.
5.
Call up the desired mode by pressing
the "OPERATION MODE SELECTOR" but-
ton.
Registering zones (Fig. 6)
It is possible to set multiple groups as one zone and
control each zone separately.
No zones are registered when the unit is shipped from
the factory.
Zone registration can be done in the individual screen,
all screen, or zone screen.
[Registration]
1.
Pressing the "ALL/INDIVIDUAL"
button for four seconds.
ZONE SET.
Zone Number 1 will be displayed, and if there are
any groups already registered in the displayed
zone, a " " will light up on the operation monitor.
404
EDUS091558E
move the
Displays
3P124623-1E