Daikin FTX-N/U Manual page 133

FTX-N/U, FVXS-N, FDMQ-R Series
2. Accessories
The following accessories are included.
Drywall screw
(2 pcs.)
3. Remote Controller Installation Procedure
3-1 Determine where to install the remote controller.
Make sure to follow the
3-2 If the control wire for the remote controller is to be routed
from the rear, consider the location of the access hole in the
lower case for making a hole in the wall.
Lower case
Through-hole
3-3 Remove upper case.
Insert a screwdriver in the recess of lower case to remove the upper case (2 points).
Remote controller printed-circuit
board is installed on the upper case.
Be careful not to damage the
printed-circuit board with the
screwdriver.
Be careful not to let dust or moisture
touch the printed-circuit board.
4
01_EN_3P243521-7L.indd 4
Drywall anchor Wire tie
(2 pcs.) (1 pc.)
Safety Considerations
1-15/16
(48.5)
Access
hole
5/16 to 3/8
(8 to 10)
Operation Installation
manual manual
(1 pc.) (1 pc.)
when determining the location.
[Unit : inch (mm)]
External view of the remote controller
5/16 to 3/8 (8 to 10)
Align the center of the wall
hole with the center of the
access hole on the controller
lower case when planning the
installation.
NOTE
If the hole size is too large or not in the proper
location, it may be seen after the remote
controller is installed.
Screwdriver
Insert and twist the screwdriver
lightly for removal.
131
EDUS091558E
Wiring retainer
(1 pc.)
Upper case
Lower case
3P243521-7L
11/27/2014 11:21:42 AM