Daikin FTX-N/U Manual page 402

FTX-N/U, FVXS-N, FDMQ-R Series
• Never use flammable spray such as hair spray,
lacquer or paint near the unit.
It may cause a fire.
• Do not allow children to play on or around the
unit as they could be injured.
• Never replace a fuse with that of wrong ampere
ratings or other wires when a fuse blows out.
Use of wire or copper wire may cause the unit to
break down or cause a fire.
• Never inspect or service the unit by yourself.
Ask a qualified service person to perform this work.
• Cut off all electric waves before maintenance.
• Do not wash the air conditioner or the remote
controller with excessive water.
Electric shock or fire may result.
• Do not touch the switch with wet fingers.
Touching a switch with wet fingers can cause electric shock.
• Never touch the internal parts of the controller.
Do not remove the front panel because some parts
inside are dangerous to touch. In addition, some
parts may be damaged by touching. For checking
and adjusting internal parts, contact your dealer.
• Check the unit stand for damage on a continuous
basis, especially if it had been in use for a long time.
If left in a damaged condition the unit may fall and
cause injury.
• Placing a flower vase or other containers with
water or other liquids on the unit could result in
a shock hazard or fire if a spill occurs.
CAUTION
• Avoid placing the controller in a spot splashed
with water.
Water coming inside the machine may cause an elec-
tric leak or may damage the internal electronic parts.
BEFORE USE
GENERAL DESCRIPTION OF SYSTEM .............. 1
SAFETY CONSIDERATIONS
FEATURES AND FUNCTIONS
NAMES AND FUNCTIONS OF THE
OPERATING SECTION
OPERATION
Individual screen, all screen, zone screen ............. 8
Batch operation and stop method ......................... 9
Group operation and stop method.......................... 9
Registering zones................................................... 9
Zone operation and stop method ......................... 10
Changing the fan direction and fan strength ........ 11
Changing the ventilation mode and
ventilation strength .............................................. 11
Timer Number Setting ......................................... 11
Setting the Operation Code.................................. 12
5
..................................................... 1
....................... 2
.................... 6
.................................. 7
........................................................ 8
• Do not operate the air conditioner when using a
room fumigation - type insecticide.
Failure to observe could cause the chemicals to
become deposited in the unit, which could endanger the
health of those who are hypersensitive to chemicals.
• Do not turn off the power immediately after stop-
ping operation.
Always wait at least five minutes before turning off the
power. Otherwise, water leakage and trouble may occur.
• The appliance is not intended for use by young
children or infirm persons without supervision.
• The remote controller should be installed in
such a way that children cannot play with it.
NOTE
• Never press the button of the remote controller
with a hard, pointed object.
The remote controller may be damaged.
• Never pull or twist the electric wire of the remote
controller.
It may cause the unit to malfunction.
• Do not place the controller exposed to direct sunlight.
The LCD display may get discolored, failing to dis-
play the data.
• Do not wipe the controller operation panel with
benzine, thinner, chemical dustcloth, etc.
The panel may get discolored or the coating peeled
off. If it is heavily dirty, soak a cloth in water-diluted
neutral detergent, squeeze it well and wipe the
panel clean. And wipe it with another dry cloth.
• Dismantling of the unit, treatment of the refriger-
ant, oil and eventual other parts, should be done
in accordance with the relevant local and
national regulations.
CONTENTS
OPERATION MODE
Setting operation mode .........................................16
Group monitoring ..................................................16
Error diagnosing function .....................................17
Setting master remote controller ..........................20
Display of time to clean .........................................21
INSTALLATION TABLE
OPTIONAL ACCESSORIES
DOUBLE CENTRAL REMOTE
CONTROLLERS
SPECIFICATIONS
Specifications .......................................................24
Outline drawings ..................................................24
Fig. 1, 2, 3, 4...............................................................3
Fig. 5, 6, 7, 8...............................................................4
Fig. 9, 10, 11, 12.......................................................25
Fig. 13, 14, 15, 16.....................................................26
400
........................................ 13
................................ 22
......................... 23
............................................... 23
............................................ 24
EDUS091558E
3P124623-1E