Daikin FTX-N/U Manual page 386

FTX-N/U, FVXS-N, FDMQ-R Series
1)
(one each on the left and right sides), and open the
panel until it stops.
2) Continue to open the front panel further while sliding the
panel to the left and pulling it toward yourself in order to
disengage the rotating shaft on the left side.
To disengage the rotating shaft on the right side, slide
the panel to the right while pulling it toward yourself.
Align the rotating shaft of the front panel with the grooves,
and push all the way in. Then close slowly.
Push both the sides and the center of the lower surface of
Rotating shaft
Push the rotating shaft
of the front panel into
the groove.
1) Remove front panel.
2)
3) Remove the screws (2) from the front grille.
4)
mark) at the top of the grille.
<
CAUTION
Be sure to wear protection gloves.
part of the front grille toward yourself to remove it.
center of the front grille, and while pushing up, pull it
toward yourself.
2) Pull toward yourself.
Indentations on
the main unit
>
1) Push up.
The service lid is of removable type.
1) Remove the single screw of the service lid.
2) Pull out the service lid frontward.
mark area
(3 locations)
Hook
1)
hooks (3 locations).
2) Insert 2 screws of the front grille.
3)
384
EDUS091558E
Hook
Push
down.
1P398933-1C