Daikin FTX-N/U Manual page 134

FTX-N/U, FVXS-N, FDMQ-R Series
3-4 Determine the location where the wiring will enter the
remote controller (back, left side, top left, top center).
3-4-1 Back outlet
Cut off resin area (notched area).
3-4-3 Top left outlet
Cut the plastic at the notched area and
remove any remaining burrs.
3-5 Install wiring.
1. Switch box and control wiring are  led supplied.
2. Do not touch the remote controller printed-circuit board.
Wiring Speci cations
Wiring Type
Wiring Size
Wiring Length Maximum 1640 feet (500 m)
01_EN_3P243521-7L.indd 5
NOTE
Non-shielded, 2-conductor, stranded copper wire
AWG-18
3-4-2 Left outlet
Cut the plastic at the notched area and
remove any remaining burrs.
3-4-4 Top center outlet
Cut the plastic at the notched area and
remove any remaining burrs.
132
EDUS091558E
5
3P243521-7L
11/27/2014 11:21:42 AM