Daikin FTX-N/U Manual page 299

FTX-N/U, FVXS-N, FDMQ-R Series
1. Operation mode selector button
● Press this button to select the operation
mode of your preference. (See page 10.)
* Available modes vary with the indoor unit
model.
2. Fan speed control button
● Press this button to select the fan speed of
your preference. (See page 11.)
* Available fan speeds vary with the indoor
unit model.
3. Menu/OK button
● Used to enter the main menu.
(See page 20 for the menu items.)
● Used to enter the selected item.
4. Up button
● Used to raise the setpoint.
● The item above the current selection will be
highlighted.
(The highlighted items will be scrolled
continuously when the button is
continuously pressed.)
● Used to change the selected item.
5. Down button
● Used to lower the setpoint.
● The item below the current selection will be
highlighted.
(The highlighted items will be scrolled
continuously when the button is
continuously pressed.)
● Used to change the selected item.
6. Right button
● Used to highlight the next items on the
right-hand side.
● Each screen is scrolled in the right-hand
direction.
01_EN_3P243520-7Q.indd 5
7. Left button
● Used to highlight the next items on the
left-hand side.
● Each screen is scrolled in the left-hand
direction.
8. On/Off button
● Press this button and system will start.
● Press this button again to stop the system.
9. Operation lamp
● This lamp illuminates solid green during
normal operation.
● This lamp  ashes if an error occurs.
10. Cancel button
● Used to return to the previous screen.
11. LCD (with backlight)
● The backlight will be illuminated for
approximately 30 seconds by pressing any
button.
● If two remote controllers are used to control
a single indoor unit, only the controller
accessed  rst will have backlight
functionality.
297
EDUS091558E
5
3P243520-7Q
3/2/2015 5:36:30 PM