Daikin FTX-N/U Manual page 371

FTX-N/U, FVXS-N, FDMQ-R Series
lights when running.
lights when connecting to a
router (wireless LAN access
point).
AP lamp (yellow)
lights when connected directly
to a smartphone.
Installation Position
Electrical wiring box
Type A model
WARNING
Be sure to turn OFF the power at the time of installation work.
Touching any electric parts with the power turned ON may cause electric shock.
1. Remove the front panel, service lid, and front grille in accordance with the installation
manual for the air conditioner.
2. Install the
Installation procedures for the
Refer to the relevant section.
For
Type A model
For Type B model
For
Other models
Names of Parts
Wireless LAN connection adapter
A
A Wireless LAN connection
adapter
HA PCB
G
HA PCB Installation Procedure (1)
Type B model
G
HA PCB.
HA PCB differ by model type.
G
Proceed to "HA PCB Installation Procedure (2)
Proceed to "HA PCB Installation Procedure (2)
D
installation manual for the air conditioner.
(It is not necessary to install the
the front grille, service lid, and front panel to their original positions.
[Resetting the connection adapter]
Use when connecting to a
If the [SETUP] button and the [MODE]
router (wireless LAN
access point). button are held down together for 5
seconds, all lamps will begin blinking.
If the [SETUP] button is pressed in
this state, settings will revert to factory
default values.
(Data including network settings and
Switches modes
power consumption history are
(RUN/AP) when held
erased.)
down.
Wiring Outline
Inside the indoor unit
S602
A Wireless LAN
connection adapter
D Connection cord
Other models
Type A
Type B
HA PCB.) After making the connection, return
G
369
EDUS091558E
S21
S601
G HA PCB
or Harness
H J
S403
Printed-circuit board
of the indoor unit
etc.
"
"
3P427537-1A