Daikin FTX-N/U Manual page 219

FTX-N/U, FVXS-N, FDMQ-R Series
SYSTEM
INDOOR
UNIT
OUTDOOR
UNIT
NOTE
• A short beep indicates non-corresponding codes.
• To cancel the code display, hold
01_EN_3P379751-4C.indd 30
„ Fault diagnosis by remote controller
• The remote controller can receive relevant error codes from the indoor unit.
1.
When
5 seconds, "
display section�
2.
Press
is produced�
• The code indication changes as shown below, and notifies you with a long beep.
CODE
00 NORMAL
UA INDOOR-OUTDOOR UNIT COMBINATION FAULT
U0 REFRIGERANT SHORTAGE
U2 DROP VOLTAGE OR MAIN CIRCUIT OVERVOLTAGE
U4 FAILURE OF TRANSMISSION (BETWEEN INDOOR UNIT AND OUTDOOR UNIT)
A1 INDOOR PCB DEFECTIVENESS
A5 HIGH PRESSURE CONTROL OR FREEZE-UP PROTECTOR
A6 FAN MOTOR FAULT
C4 FAULTY HEAT EXCHANGER TEMPERATURE SENSOR
C9 FAULTY SUCTION AIR TEMPERATURE SENSOR
EA COOLING-HEATING SWITCHING ERROR
E1 CIRCUIT BOARD FAULT
E5 OL STARTED
E6 FAULTY COMPRESSOR START UP
E7 DC FAN MOTOR FAULT
E8
OVERCURRENT INPUT
F3
HIGH TEMPERATURE DISCHARGE PIPE CONTROL
F6
HIGH PRESSURE CONTROL (IN COOLING)
H0
SENSOR FAULT
H6
OPERATION HALT DUE TO FAULTY POSITION DETECTION SENSOR
H8
DC CURRENT SENSOR FAULT
H9
FAULTY SUCTION AIR TEMPERATURE SENSOR
J3
FAULTY DISCHARGE PIPE TEMPERATURE SENSOR
J6
FAULTY HEAT EXCHANGER TEMPERATURE SENSOR
L3
ELECTRICAL PARTS HEAT FAULT
L4 HIGH TEMPERATURE AT INVERTER CIRCUIT HEATSINK
L5 OUTPUT OVERCURRENT
P4 FAULTY INVERTER CIRCUIT HEATSINK TEMPERATURE SENSOR
down for about 5 seconds. The code display also clears if no button is pressed for 1 minute.
is held down for about
" blinks in the temperature
repeatedly until a continuous beep
MEANING
217
EDUS091558E
When the Need Arises
30
C: 3P379751-4C
11/6/2015 16:14:53