Daikin FTX-N/U Manual page 374

FTX-N/U, FVXS-N, FDMQ-R Series
Wireless LAN Connection Adapter Installation Procedure
The following procedures are also applicable to air
A
Press a slot-head screwdriver* into the dent between the
upper and lower cases of the
adapter to remove. (Be careful not to damage the case.)
* Use a slot-head screwdriver with a wide head (0.2 inches
(5mm) or wider is recommended).
A
1) Attach the connector of the
2) Fasten the
D
case of the A
easily removed for maintenance purposes.
Close the adapter by hooking the top of the
upper case on the top clip of the lower case.
wireless LAN connection
A
D
D connection cord.
connection cord to the notch in the lower
wireless LAN connection adapter.
A
Top clip of lower
case
A
Wireless LAN connection adapter
A
Do not press the
screwdriver into
the hole for the
connection cord.
Slot-head screwdriver
Connector
F Mounting screws
When attaching the
Attach it to the reverse side of the lower case.
Do not
fasten the
Depending on the type of the wall, there is a
screws
possibility of damaging the wall, and the
into the
adapter falling.
indoor unit.
Please install it after consulting with the client.
Push until you hear a click.
When turning on the power, always
attach the upper adapter case.
372
EDUS091558E
All types
Upper
case
Lower
case
Ensure that the connector on
the D connection cord is
Cord anchor
D
Fasten the connection
cord and ensure that
external force is not
transmitted.
E fastening tape
Do not block the
holes at the top
and bottom.
E Fastening tape
Check that the
connection cord is
D
securely fastened.
3P427537-1A