Daikin FTX-N/U Manual page 466

FTX-N/U, FVXS-N, FDMQ-R Series
4.
Route the harnesses.
WARNING
hen drilling a hole be careful not to damage the soundproo ng material and other components on the back side.
For type A models
1) If there is no hole drill a 1/8 inch ( 3.2mm) hole in the partition plate. (1 location)
2) Fix in place the binding band attached to the
the hole. (1 location)
3) Install the fan motor base.
Be careful not to confuse screw types. Refer to "Installation Procedure (2)".
4) Place the
For type B and C models
1) If there are no holes drill 1/8 inch ( 3.2mm) holes in the partition plate. (3 locations)
2) Fix the
A
3) Install the fan motor base.
Be careful not to confuse screw types. Refer to "Installation Procedure (2)".
4) Trim the electrical wiring box with nippers at the locations shown in the gures then cover the trimmed edges with
the sealing material.
D
5) Insert the
Binding bands
M4 piercing
B
screws
Installation Procedure (4)
A drain pan heater harness on top of the fan motor harness and x it in place with the
Binding band
If a hole need to be drilled hold the component
M4 piercing screw
B
in position to determine the location of the hole.
drain pan heater harness in place by screwing the
drain pan heater harness into the space that was trimmed and x it in place using the
A
If holes need to be drilled hold the
component in position to determine
the locations of the holes.
drain pan heater harness by screwing the
A
M4 piercing screws into the holes. (3 locations)
B
Type C
Trim the electrical wiring box.
Type B
Trim the electrical wiring box.
464
EDUS091558E
M4 piercing screw into
B
D sealing material.
Fan motor harness
Sealing material
D
Drain pan
A
heater harness
sealing material.
D
Sealing materials
D
Sealing materials
D
3P421082-1C