Daikin FTX-N/U Manual page 357

FTX-N/U, FVXS-N, FDMQ-R Series
2. Securing the remote control adapter
Remove the upper case of the remote control adapter
and secure the lower case assembly.
3. Wiring
Tie-band
(to secure the cord)
Tie-band
(to secure the cord)
Remote controller
board
(Cord drawn out on the back)
4. Placing the upper case assembly of the remote controller and the upper case of the remote controller adapter back into their original positions
Catch the lower hook first.
During mounting of the remote
controller cord, be careful not to pinch
or otherwise damage the wires.
(Remote controller cord 4 wire)
5. Temperature indication change
To change from Celsius temperature indication to Fahrenheit one
Press and hold down
same time for 5 seconds while the
Celsius temperature is indicated.
Wood screws (φ3.5mm x 16mm)
(Mounting with supplied wood screws)
Remote control adapter (attached)
To indoor unit S21-HA connector
Connector
Attached
five-wire cord
Remote controller cord
(Note 1)
Lower case
Connector
Remote controller
board
Upper case
assembly
(Cord drawn out on the top)
at the
← See Operation Manual
(Mounting with supplied double-face adhesive tape)
Using wire cutters, make
a notch for wiring and
then seal the notch to
ensure it is waterproof.
Note 1) Ground the both ends of the shielded wire.
Remote controller cord 4 wire
Item No.
BRCW901A03
Connector
BRCW901A08
Tie-band
(to secure the cord)
To remote control adapter
355
EDUS091558E
Double-face
adhesive tape
Length
Approx. 3m (10ft)
Approx. 8m (26ft)
3P202923-2B