Daikin FTX-N/U Manual page 390

FTX-N/U, FVXS-N, FDMQ-R Series
e o al etho
1)
(one each on the left and right sides), and open the
panel until it stops.
2) Continue to open the front panel further while sliding the
panel to the left and pulling it toward yourself in order to
disengage the rotating shaft on the left side.
To disengage the rotating shaft on the right side, slide
the panel to the right while pulling it toward yourself.
Installation
Align the rotating shaft of the front panel with the grooves,
and push all the way in. Then close slowly.
Push both the sides and the center of the lower surface of
e o al etho
1) Remove front panel.
2)
with a streamer unit).
3) Remove the screws (3) from the front grille.
4)
mark) at the top of the grill.
< When there is no
unit is lose to eiling >
part of the front grill toward yourself to remove it.
center of the front grille, and while pushing up, pull it
toward yourself.
Installation
1)
2) Insert 3 screws of the front grille.
3)
e o al an Installation of ront Panel
etho
e o al an Installation of ront
or spa e e ause the
etho
Rotating shaft
Push the rotating shaft
of the front panel into
the groove.
rille
mark area
(3 locations)
Hook
1) Push up.
2) Pull toward yourself.
388
EDUS091558E
Indentations on
the main unit
Hook
Push
down.
CAUTION
Be sure to wear
protection gloves.
3P363899-2D