Daikin FTX-N/U Manual page 306

FTX-N/U, FVXS-N, FDMQ-R Series
Basic Operation
5
6
Characteristics of Heat Mode
The system automatically controls the following operating modes to
prevent the reduction of heating capacity and space comfort.
Defrost operation
Hot start
12
01_EN_3P243520-7Q.indd 12
● Adjust Air ow Direction from the main menu
(see page 23)
* If the connected indoor unit does not have oscillating louvers,
this function will not be available.
● When On/Off button is pressed again,
the system will stop operating and the
On/Off
Operation lamp will turn off.
* When the system is stopped while in the heating
mode, the fan will continue to operate for
approximately one minute to remove residual
heat from the indoor unit.
Note
● To prevent condensation water damage or system failure, do not
shut off the power supply to the indoor unit immediately after
operation. Wait at least  ve minutes for the condensate pump to
 nish draining residual water from the indoor unit.
● The system will automatically go into defrost operation to prevent frost
accumulation at the outdoor unit and subsequent loss of heating
capacity.
● The indoor unit fan will stop, and "
remote controller.
● The system will  nish the Defrost operation and return to normal
usually within six to eight minutes. It won't last for more than ten
minutes.
● When the system starts heating operation, the indoor unit fan will
operate with a delay in order to prevent a cold draft.
(In that case, " STANDBY " will be displayed on the remote controller.)
.
STANDBY " will be displayed on the
304
EDUS091558E
3P243520-7Q
3/2/2015 5:36:32 PM