Change And Cancellation Of No. Of Programmed Time - Daikin FTX-N/U Manual

FTX-N/U, FVXS-N, FDMQ-R Series
(2) Set the next day of the week.
Set the day of the week to Tuesday, and
copy the program of the previous day
(Monday). In the same procedure, set the
day of the week to Wednesday through Fri-
day in sequence.
6. Press the BUTTON FOR
6
SELECTING DAYS OF A WEEK
and set the following day. Press
the BUTTON FOR COPYING PRO-
GRAM OF PREVIOUS DAY. The
same program as that of the imme-
diately preceding day of the week
is set.
(NOTE)
• Repeat each procedure 3 – 5 in the
above when not copying the contents of
the previous day.
(3) Holiday setting
7. Press the BUTTON FOR
7
SELECTING DAYS OF A WEEK
and set one or more days of the
week as holiday. Press the HOLI-
DAY SETTING BUTTON, and the
display " OFF " is displayed at the
top of the day of the week. If you
press it again, the display returns
to the original state.
Set Saturday and Sunday as holidays.
8. Press the PROGRAMMING
8
START BUTTON, and finish the
program setting.
(NOTES)
• Unless the button is pressed within 20
minutes, the display will automatically
revert back to the original state. In this
case, setting contents up to the point
where the TIMER ON BUTTON (or HOL-
IDAY SETTING BUTTON or BUTTON
FOR COPYING PROGRAM OF PREVI-
OUS DAY) is pressed will only take
effect.
• The display " PROGRAM
and the display of days of a week " — "
disappears.
7
• The flashing display goes off, and the
No. of programmed time of the present
day is displayed. Then the operation
controlled by timer starts.
• The operation controlled by timer is exe-
cuted even while the program is being
set.
This is the end of the setting example.
Change and cancellation of no.
of programmed time (Fig. 5)
(Example)
Operating from
8:45 a.m. till
5:00 p.m.
Operating from
5:15 p.m. till
11:00 p.m.
1. Press the PROGRAMMING
1
START BUTTON. The program
setting is ready. The display
" PROGRAM
and the display of days of a week
flashes.
2. Press the TIME No. BUTTON,
2
and select the desired No.
Select the time No. 3.
START "
443
Time No. 3 (to be set only when
used in conjunction with the
central remote controller)
A: Change/
cancel partially
(Wednesday)
After operating
from 8:45 a.m.
till 7:00 p.m.,
the operation
stops.
B: Cancel the
whole
(Thursday)
Whole day
stop.
START " appears,
EDUS091558E
3P124623-5C