Display Vlan - 3Com 5500-EI PWR Reference Manual

Parameter
vlan-id: ID of the specific VLAN interface.
Description
Use the display interface Vlan-interface command to display the information about the VLAN
interface.
VLAN interface is a virtual interface in Layer 3 mode, used to realize the layer 3 communication
between different VLANs. Each VLAN has a VLAN interface, which can forward packets of the local
VLAN to the destination IP addresses at the network layer.
If the vlan-id argument is specified, the information about the specified VLAN interface is displayed; if
the vlan-id argument is not specified, the information about all the created VLAN interfaces is displayed.
Related command: interface Vlan-interface.
Example
# Display the information about VLAN-interface2.
<Sysname> display interface Vlan-interface 2
Vlan-interface2 current state : DOWN
Line protocol current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 000f-e207-4101
Internet Address is 10.1.1.1/24 Primary
Description : Vlan-interface2 Interface
The Maximum Transmit Unit is 1500
Table 1-1 Description on the fields of the display interface Vlan-interface command
Vlan-interface2 current state
Line protocol current state
IP Sending Frames' Format
Hardware address
Internet Address
Description
The Maximum Transmit Unit

display vlan

Syntax
display vlan [ vlan-id [ to vlan-id ] | all | dynamic | static ]
View
Any view
Parameter
vlan-id: VLAN ID, in the range of 1 to 4094.
Field Description
Current state of the VLAN interface
Current state of the link protocol
Format of the frames that IP sends
MAC address corresponding to the VLAN interface
IP address corresponding to the VLAN interface
Description string of the VLAN interface
Maximum transmission unit (MTU)
1-2