Set Standby Switch Fabric Module To Suspended/ In-Service Mode; Sis: Stand-By In-Service/Suspended - 3Com CoreBuilder 9000 User Manual

Set Standby Switch
Fabric Module to
Suspended/ In-service
Mode
Set the standby switch fabric module to suspended/in-service mode.
When the standby switch fabric module is suspended, it cannot be used
to replace the active switch fabric module.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 4 3 2
The following prompt is displayed:
Put Stand-by Switch to Suspended mode!
Are you sure (Y/N)? y
The following message is displayed:
Stand-by Switch mode changed to Suspended mode.
Managing Switch Fabric Modules
(4) SWM: Switch modules
(3) SSM: Stand-by Switch Module
(2) SIS: Stand-by
In-service/Suspended
1 4 3 2
The standby switch is set to suspended/in-service
mode.
Stand-by Switch mode changed to
Suspended/In-Service mode.
99