Basic Procedures; Connector Hook-Up Work; Cutting Of Exclusive 4-Core Flat Cable - Panasonic S-LINK V User Manual

Connector hook-up work

This section describes the knowledge and setup method to be learned before starting connector hook-up work.
CAUTION
● If a connector is not hooked-up correctly, the S-LINK V system will not work.
● If a connector is once hooked-up, do not use the connector again.
This is because the performance of a used connector may be deteriorated.
● Before starting hook-up work, be sure to turn off the power.
● When you disconnect or reconnect a connector, be sure to grab the connector main body.
If you pull the cable to disconnect or reconnect a connector, the cable may be disconnected.
● Do not hook-up any connector in a cold weather, such as outdoors in winter.

Cutting of exclusive 4-core flat cable

Cut the exclusive 4-core flat cable so that the end face of the cable can be orthogonal.
CAUTION
● Cut the exclusive 4-core flat cable so that the end face of the cable can be orthogonal.
If the end face is not orthogonal, the connector may not be hooked-up properly.
● Do not peel the sheath of the exclusive 4-core flat cable.
● After cutting the exclusive 4-core flat cable, check that the cores are not in contact with each other.
Orthogonal
Good Not good Not good Not good

Basic Procedures

String
Peeling of sheath
37