Connection Of I/O Device - Panasonic S-LINK V User Manual

Construction

Connection of I/O device

CAUTION
Connect input device to the SL-VT□E, and connect output device to the SL-VTP□E. If it is connected
wrong, it may cause brekage.
The I/O device connection method depends on the connection-to unit.
● To connect an I/O device to the SL-VT□J and SL-VTP□J
1.
Attach the SL-CP1, SL-CP2, or SL-CP3 snap male connector to
the cable distributed from the I/O device. (For the hook-up meth-
od, refer to pages 37, 38, and 44, 45.)
2.
Connect the snap connector to the connector I/O unit.
CAUTION
Insert the snap male connector all the way into the slot.
If the connector is not inserted all the way into the slot, the connector may cause imperfect contact,
and the system may malfunction.
● To connect an I/O device to the SL-VT□E and SL-VTP□E
● Connect an e-CON conforming connector (4P type) that is launched
by various manufactures to the cable distributed from the I/O device.
For the instruction of e-CON spec. based connector, contact manu-
factures of e-CON conforming connector.
56
Connector I/O unit
Snap male connector
Cable of connected device
4-core flat cable
e-CON connector
I/O unit
e-CON conforming connector (4P type)
(Please arrange separately.)
Cable of the connected device
4-core flat cable
Pin No. Input device Output device
1 +24V
2 0V
3 Input No connection
4 No connection
Pin No. Input device Output device
1 +24V
2 N.C.
3 0V
4 Input
Note: Make sure that the pin configuration is dif-
ferent between SL-VT□J and SL-VT□E.
Output
Output