Control Board - Panasonic S-LINK V User Manual

Control board

There are 2 types of control boards: control boards for PCI bus, and VME bus.
Select a control board optimum for your bus.
● Part description
<SL-VPCI>
8
7
6
5
No. Designation
S-LINK V terminal block
1
connector
2 Board No. setting switches
Transmission mode set-
ting switches
3
I/O control points setting
switches
4 I/O setting switches
System setting button for
5
port 1
Transmission indicator
6
(Green)
7 BUSY indicator (Orange)
8 Error indicator (Red)
1
SW5
SW1
1: G
2: D
3: 0V
4: +24V Use these connectors to connect the power supply and signal lines of the S-LINK V system.
5: 0V
6: +24V
7: F.G.
Use these switches to set the SL-VPCI board No.
Using the rotary switch, set the range to 0 to F, and you can set up to 16 board Nos. for the same bus.
Use the transmission mode setting switches to set the transmission mode to A mode, B mode, or C
mode.
Use the I/O control points setting switches to set the number of I/O control points.
Transmission mode setting switches
Use these switches to set the I/O (for I/O of every 32 points).
Use this button to read and store the unit connection condition data.
After this, the system will use this data to check for errors 3, 4, and 5.
This indicator will blink during transmission (when the transmission signal is being output).
The indicator blinking cycle depends on the transmission speed.
This indicator will light up during system setting operation or transmission check operation.
This indicator indicates the error status as follows:
• Lights up when an error occurs.
• Blinks when the cause of the error is eliminated.
3
SW2
2
Function
ON
1 2 3 4 5 6 7 8
I/O control points setting switches
Not used
Specifications
4
SW3 SW4
87