Panasonic S-LINK V User Manual page 88

Specifications
<SL-VVMES2>
No. Designation
S-LINK V terminal block
1
connector for port 1
S-LINK V terminal block
2
connector for port 2
I/O first address setting
3
switches
Transmission mode set-
ting switches for port 1
4
I/O control points setting
switches for port 1
Transmission mode set-
ting switches for port 2
5
I/O control points setting
switches for port 2
6 I/O setting switches for port 1
7 I/O setting switches for port 2
8 System setting button for port 1
9 System setting button for port 2
Transmission indicator
10
for port 1 (Green)
Transmission indicator
11
for port 2 (Green)
BUSY indicator for port 1
12
(Orange)
BUSY indicator for port 2
13
(Orange)
14 Error indicator for port 1 (Red)
15 Error indicator for port 2 (Red)
Interruption level setting
16
swithces
17 Status / ID setting switches
88
10
12
14
8
SW10
11
13
SW11
15
9
1
2
7: F.G.
6: +24V
5: 0V
4: +24V
3: 0V
2: D
1: G
Use these connectors to connect the power supply and signal lines of the S-LINK V system.
7: F.G.
6: +24V
5: 0V
4: +24V
3: 0V
2: D
1: G
Use these switches to set two upper digits of the first short address of the VME bus (address consists of
4 digits of hexadecimal numbers).
Use the transmission mode setting switches to set the transmission mode to A mode, B mode, or C
mode.
Use the I/O control points setting switches to set the number of I/O control points.
Transmission mode setting switches
Use these switches to set the I/O (for I/O of every 32 points).
Use this button to read and store the unit connection condition data.
After this, the system will use this data to check for errors 3, 4, and 5.
This indicator will blink during transmission (when the transmission signal is being output).
The indicator blinking cycle depends on the transmission speed.
This indicator will light up during system setting operation or transmission check operation.
This indicator indicates the error status as follows:
• Lights up when an error occurs.
• Blinks when the cause of the error is eliminated.
Use these switches to set the VME bus interruption level (IRQ1 to IRQ7).
Use these switches to set the status / ID using binary numbers.
The status / ID will be transmitted at VME bus interruption.
16 17
SW8
SW7
3
SW9
SW1
6
SW2
4
SW3
SW4
7
SW5
5
SW6
Function
ON
1 2 3 4 5 6 7 8
I/O control points setting switches
Not used