Common Specifications; Address Setting Switches - Panasonic S-LINK V User Manual

Specifications

Common Specifications

Transmission method
Synchronization method
Transmission procedure
Transmission speed
Refresh time (Note 1)
Number of I/O control
points
Number of connected
nodes
Transmission distance
Total cable length
Exclusive 4-core flat cable (0.5mm
Transmission cable
to 2.0mm
Notes: 1) For a detailed description of refresh time and response delay time, refer to page 28.
2) The VCTF cord is the vinyl cabtyre cord that conforms to the requirements of JIS C3306 'Polyvinyl chloride insulated flexible cords.'

Address setting switches

CAUTION
To change the set position (ON / OFF position) of an address setting switch, use a tool having a hard
and sharp tip, such as a flathead screwdriver.
To set the address of each S-LINK V unit, use the address setting switches installed on each unit.
● PLC I/O connector
CAUTION
The connector number setting switches on each PLC I/O connector has different functions compared
with the address setting switches on each I/O unit.
72
Bidirectional time-division multiple transmission method
Bit synchronization method, frame synchronization method
2
) or 4-core VCTF cable (non-shielded) having conductor cross section of 0.3
2
(Note 2)
1 2
Connector number setting switches
S-LINK V protocol
A mode: 110kbps
B mode: 27.5kbps
C mode: 6.9kbps
A mode: 0.29 to 10.32ms
B mode: 1.18 to 41.29ms
C mode: 4.70 to 165.15ms
Max. 512 points
Max. 256 nodes
A mode: Max. 50m
B mode: Max. 200m
C mode: Max. 800m
A mode: 100m or less
B mode: 400m or less
C mode: 1,600m or less
4 8
ON